Dekolink Deko3108S Product Manual page 13

D W L .
EKOLINK IRELESS TD
1.4.2 Internal Interfaces
This section describes the Repeater interfaces that are accessed by opening the
Repeater. There are two such interfaces:
• The Ethernet port
• Power level selector – for service personnel only. This connector is relevant only if
the option is enabled from the Web GUI application 4.3.
1.4.2.1 Ethernet Port
During installation, you will be required to open the enclosure door in order to access
Ethernet
the
Note: The Ethernet communication port is the only port that is relevant to the user.
Ethernet port connection
(Accessed by opening
Repeater door and inserting
cable through curtained slot)
1.4.2.2 Internal Power Selector (for service personnel)
The Max Gain is factory set to its minimum value by default. The RF power level can be
modified either through the GUI (default - 4.3.) or through the internal selector located
in the Repeater (service personnel only).
The Repeater is factory set to allow this configuration
internal selector is disabled.
power level, the option must first be enabled in the GUI by setting the LBDA Params
Mask (section 4.3); otherwise any changes in setting via this switch are not relevant.
NOTE: The UL and DL LEDs can be used to provide some indication of the UL and DL
signal levels. However, it is recommended to use the WEB access application advanced
monitoring capabilities to monitor and troubleshoot the Repeater.
P/N 300XC10031 Rev. B
D 3108S M
EKO IDI
communication port located (on the CMU unit as illustrated below).
Figure 1-3. CMU Front Panel
In order to use the selector in the unit to set the CDMA
Proprietary Data
R
EPEATER
only through the GUI – the
P M
RODUCT ANUAL
Page 11