Britax Safe-n-sound BS8100A-020133 Series Instructions For Installation & Use page 71

ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE BOLT IS
NOT THE CORRECT LENGTH THE CAR MANUFACTURER'S
HAND BOOK CAN PROVIDE ADVICE ON THE CORRECT
LENGTH BOLT.
CHILD RESTRAINTS MUST NOT BE ATTACHED TO
UNSOUND METAL OR TO WOOD, OR SYNTHETIC
STRUCTURES. WHEN DRILLING 9 MM HOLE DO NOT
DRILL THROUGH FUEL LINES, FUEL TANKS, ELECTRICAL
WIRING, OR RADIO SPEAKERS.
WEBBING STRAPS MUST BE PROTECTED FROM SHARP
CORNERS AND EDGES. THE ANCHOR FITTING MUST BE
USED ONLY AS DESCRIBED ABOVE. IT MUST NOT BE
HOOKED ONTO ANY OTHER OBJECT.
CARINSTALLATIONACCESSORIES
(FromretailersofBritaxSafe-n-Soundproducts)
EXTRA ANCHOR KITS: Available for using the restraint in additional cars.
Re-order no: 0038
EXTENSION STRAPS: May be required for cars without a fixed parcel shelf.
Re-order no: 0035 (length 300mm) or
0036 (length 600mm)
INSTALLATIONOFCARUPPER                            
Instructions for Installation & Use - Series No. BS8100A-020133
ANCHORAGEPOINT
NOTE: Marking on
the top of a Grade 5
Bolt. Do not use any bolt
without these marks.
Fig.3.
Front of Vehicle
200mm
min.
Centre line of
seating position
71