Britax Safe-n-sound BS8100A-020133 Series Instructions For Installation & Use page 35

STORINGTHEHARNESS
A. Disengage harness buckle. Fully lengthen the harness
by pressing the Harness Adjustment lever and pulling
the harness shoulder straps.
B. At the rear of the restraint, remove both harness
shoulder straps from metal Strap Connector by
slipping strap through open slot. The metal Strap
Connector is shown in diagram right.
C. Pull the shoulder straps through slots in the seat back.
D. Remove the Elastic loops holding the cover in place at
the lower front of the seat. Lift the cover to expose the
storage inserts in the seat base.
E. Feed the straps with harness tongues through the
bottom rear of the seat cover. Roll up each harness
strap with harness tongue and place into the left and
right rear recess in the seat base (underneath the
cover).
Instructions for Installation & Use - Series No. BS8100A-020133
HOWTOSET-UP
Pull to
lengthen
Lift
Strap Connector
A
B
E
35