Britax Safe-n-sound BS8100A-020133 Series Instructions For Installation & Use page 56

HOWTOINSTALLCHILDHARNESS
D. Hook the SecureGuard™ Device over the lap belt
and engage the vehicle seat belt tongue to the
buckle. Check and adjust the seat belt to sit firmly but
comfortably around the child's pelvis. The seat belt
buckle should be located as low as possible below
the child's hip.
E. If the child harness extension strap is used, adjust
this before removing slack from the child harness.
Ensure to keep it as short as possible while allowing
the child harness to be adjusted to suit the child.
F. With the lap belt (or converted lap/sash) and
SecureGuard™ Device adjusted to be a firm fit
on the child's thighs, adjust the Child Harness
to remove all slack in the shoulder straps. Once
adjusted, further adjustments are necessary only to
accommodate the growth of the child.
G. Finally, roll up the free end of the harness adjuster
strap, place it on the top of the adjuster and secure
using the storage strap. Close the cover pad.
Always secure the loose end of the top tether strap to
prevent it hanging out of the car or being accessible
by the child.
H. Lengthen the harness at any time by fully pressing
the Adjuster Button (1) whilst pulling the shoulder
strap (2) upwards.
Refer to child harness fitting instructions for further
details.
56
Instructions for Installation & Use - Series No. BS8100A-020133
Adjuster
Cover
Storage Strap
Fold the adjuster strap and
secure with Storage strap.
2
1