Britax Safe-n-sound BS8100A-020133 Series Instructions For Installation & Use page 70

INSTALLATIONOFCARUPPER
ANCHORAGEPOINT
IFTHECARISFITTEDWITHCHILDRESTRAINT
UPPERANCHORAGEPOINT
Locate the upper anchorage point behind the rear seating
position. (Consult the car owners handbook for the location of
the upper anchorage point). The upper anchorage point should
be directly behind and central to the restraint. Remove thread
plug from the parcel shelf/floor/roof, etc. and install attachment
bolt and fitting as shown in Fig 1.
CAUTION: DO NOT OVERTIGHTEN ATTACHMENT BOLT.
OVERTIGHTENING MAY FRACTURE OR BREAK BOLT.
MAXIMUM TORQUE IS 20 Nm(14.75 ft.lb.)
Note: Minimum of five full turns of attachment bolt is required
before tightening force is applied.
IFTHECARISNOTFITTEDWITHCHILD
RESTRAINTUPPERANCHORAGEPOINTS
ForSedansonly - Drill 9mm diameter hole in the parcel
shelf on the centre line of the seating position as shown in Fig
3. Before drilling the hole, check the underside for accessibility.
Install the attachment bolt as shown in Fig 2. It is recommended
that this installation be carried out by a child restraint fitting
station or licenced motor mechanic.
ForvehiclesotherthanSedans- In Australia, consult
your nearest child restraint fitting station or traffic authority
for vehicle inspection to find the best, correct position for
the placement of the upper anchorage point, and for the
correct attachment bolt length and use of spacers. In New
Zealand, consult the agent for the vehicle. Note to Queensland
purchasers: The installation of anchorage points must be
approved by authorised officers appointed by Queensland
Transport. Authorised officers can be sourced from all
Queensland Transport Customer Service and Queensland
Ambulance Service Centres.
70
Instructions for Installation & Use - Series No. BS8100A-020133
UPPERANCHORAGEFITTING
Fig.1.
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Front of Vehicle
UPPERANCHORAGE
FITTINGSFORSEDANSONLY
Fig.2.
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Reinforcing
washer (cone
downwards).
Lock washer
Secure nut