19_Computer Battery Replacement - Keiser M7i Installation And Operation Manual

M7i WHEELCHAIR-ACCESSIBLE TOTAL BODY TRAINER
COMPUTER BATTERY REPLACEMENT
"LO-BA" will appear on the computer to indicate that the batteries are low and need replacement. To replace the batteries:
1. Remove the battery compartment screw using a #1 Phillips screwdriver (refer to Figure 17). Use a flat, blunt object
such as a credit card to pry the cover from the rear of the computer housing.
2. Remove the two D batteries (follow manufacturer's recommendations for handling, maintaining, and disposing of
batteries).
3. Install two new D batteries observing the correct polarity (see +/- marking inside the battery compartment). R6 (Zinc-Carbon)
or LR6 (Alkaline) type batteries are acceptable. Do not use FR6 (Lithium) or similar type batteries.
4. Replace the battery compartment cover onto the computer housing and reinstall the screw.
WARNING: Install batteries correctly (+/-). Do not disassemble or dispose of batteries in fire.
Check local government guidelines for battery disposal/recycling in your area. Battery leakage is
extremely caustic and contact with bare skin should be avoided. Follow battery manufacturer's
recommendations for care and use.
NOTE: Upon end of life of your M7i, contact Keiser Customer Support for handling direction (see back page for contact information).
M SERIES CALIBRATION
All M Series equipment is factory calibrated. There is no need to calibrate. If a component associated with the resistance
mechanism or computer has been replaced, contact Keiser Customer Support for the calibration procedure (see back page
for contact information).
Figure 17. M7i Batteries Replacement
19