Computer Battery Replacement - Keiser M7i Installation And Operation Manual

M7i WHEELCHAIR-ACCESSIBLE TOTAL BODY TRAINER

COMPUTER BATTERY REPLACEMENT

"LO-BA" will appear on the computer to indicate that the batteries are low and
need replacement. To replace the batteries:
1. Remove the battery compartment screw using a #1 Phillips screwdriver (refer
to Figure 14). A flat, blunt object, such as a credit card may be used to pry
the cover from the rear of the computer housing.
2. Remove the two D batteries (follow manufacturer's recommendations
for handling, maintaining, and disposing of batteries). Install two new D
batteries observing the correct polarity (see +/- marking inside the battery
compartment).
3. Replace the battery compartment cover to the computer housing and reinstall
the screw.
NOTE: Upon end of life of your M7i, contact Keiser Customer Support at 1 559 256 8000 for handling direction.
Be sure to follow your local government guidelines for battery disposal/recycling.
WARNING: Install batteries correctly (+/-). Do not disassemble or dispose of batteries in fire.
Check local government guidelines for battery disposal/recycling in your area. Battery leakage
is extremely caustic and contact with bare skin should be avoided. Follow battery manufacturer's
recommendations for care and use.
M SERIES CARDIO CALIBRATION
All M Series equipment is factory calibrated. There is no need to calibrate. If a component associated with the resistance
mechanism or computer has been replaced, contact Keiser Customer Support at 1 559 256 8000 for the calibration
procedure.
REGULATORY AND COMPLIANCE NOTICES
COMPLIANCE
This device complies with Industry Canada Licence-Exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le present appareil est conforme aux CNR d'industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisee aux deux conditions
suivantes: (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioelectrique subi, meme si le brouillage est susceptible
d'en compromettre le fonctionnement.
REGULATORY NOTICE
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
California Proposition 65 Warning: This product contains chemicals known in the State of California to cause
cancer, birth defects, and/or other reproductive harm.
*BLUETOOTH ® word mark and logos are registered trademarks of Bluetooth SIG, Inc.; HYDROTEX
smart
Partners, Ltd.; MEGUIAR'S is the registered trademark of Meguiar's, Inc.; and POLAR
®
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV
technician for help.
® is the registered trademark of Hydrotex,
is the registered trademark of Electro Oy.
®
17
Figure 14. Battery
Compartment Removal