12_Recoiler Safety Straps; 12_Adjustment Knobs - Keiser M7i Installation And Operation Manual

M7i WHEELCHAIR-ACCESSIBLE TOTAL BODY TRAINER
FOOTSTRAPS
Individuals with limited lower body control should always secure their
feet with Foot Straps when operating the M7i. To set and fasten the
Footstraps, refer to Figure 9 and follow the instructions below:
1. Place your foot under the Foot Strap and onto the Footpad with
your heel resting against the rear wall of the Footpad.
2. Pull the Foot Strap end up and away from your foot to tighten the
Foot Strap to your foot.
3. Press the hook and loop surfaces firmly together to fasten. Ensure
the Foot Strap is snug to fit without causing discomfort.
CAUTION: Always wait for the M7i to come to a complete stop before
attempting to adjust the Foot Straps.
RECOILER SAFETY STRAPS
Recoiler Safety Straps help increase wheelchair stability and must be used at all times during exercise. Wheelchair brakes must
be locked during exercise (powered mobility devices turned off). To set the Recoiler Safety Straps, follow the instructions below.
1
A
Lock Lever
Recoiler Safety
Strap/Hook
(A) Lift the Recoiler Lock Lever up to
unlock and (B) pull the Safety Strap Hook
out.
NOTE: When done exercising, lift the Recoiler Lock Lever up to unlock. Detach the Safety Strap Hooks and allow them to feed
back into the Recoilers.
ADJUSTMENT KNOBS
The Adjustment Knobs allow the Handles to adjust in increments of 1 inch
(25 mm) to attain a comfortable reach distance. To set the Handles using
the Adjustment Knobs, refer to Figure 10 and follow the instructions below:
1. Loosen the Adjustment Knob by turning it counterclockwise 1/4 -
1/2 turn.
2. Pull the Knob outward and hold.
3. Slide the Handle freely to the desired position.
4. Release the Knob. Ensure it locks into the desired position hole.
5. Turn the Knob clockwise until it is hand-tight to secure the Handle.
NOTE: For proper reach setting, ensure that your elbows maintain a
slight bend when the Handles are pushed out to the furthest position.
2
B
Attach the Safety Strap Hooks above
Seat Level (i.e. arm rest).
CAUTION: TIP HAZARD. Safety
Strap Hooks attached below Seat Level
increases the chance of tipping backwards
and could result in bodily injury. Always
attach Safety Strap Hooks ABOVE SEAT
LEVEL.
3
Figure 9. How to Fasten the Footstraps
3
Seat Level
Lock Lever
(A) Check for tightly drawn Recoiler
Safety Straps with no looseness, then
(B) push the Recoiler Lock Lever down
to lock in place. If your wheelchair feels
like tipping back, stop in a controlled
manner and repeat the entire procedure
to adjust the Safety Straps until stability
is achieved.
Adjustment Knob
3
Figure 10. How to Adjust the Handles
12
2
1
B
A
Straps are

Tight
1
5
4
Handle
2