Table of Contents
Advertisement
PERFORMANCE TRAINER | OPERATION MANUAL
BATTERY REPLACEMENT
Do not operate the equipment during battery replacement procedure. "Lo-bA" = Batteries are low, replace immediately.
NOTE: If batteries are dead (depleted), the Power Display remains blank. To replace the batteries, refer to Figure 11 and
follow the instructions below.
Tools Required:
#3 Phillips screwdriver
PROCEDURE:
1.
Open the Performance Trainer by removing
the five Phillips Screws along the left side.
2. Locate the Processor Box at the base. Unscrew
the brass nut to remove cover.
3. Remove the two D batteries by carefully pulling
out the battery sleeve (follow manufacturer's
recommendations for handling, maintaining,
and disposing of batteries).
4. Observe the correct polarity position (see +/-
marking on the circuit board), insert the two
new D batteries into the battery sleeve and
install.
• The Power Display will enter a brief test
sequence (you will see a series of numbers
flashing).
IMPORTANT: Once the test sequence ends
(numbers stop flashing), press either the
increase or decrease Thumb Button and allow
the machine to enter sleep mode ("OFF") to
resume normal operation.
5. Replace the Processor Box cover and screw
the brass nut finger tight.
6.
IMPORTANT: Avoid pinching the Air Line.
Route the Air Line along the notch at the base.
Close the Performance Trainer, align all screw
holes and fasten with the screws removed in
Step 1.
Do not dispose of batteries in a fire. The
batteries may explode.
Do not open or mutilate batteries. They
contain an electrolyte which is toxic and
harmful to the skin and eyes.
Figure 11. Battery Replacement
CAUTION
Replace batteries with the same number
and type of batteries as originally installed
in the equipment.
Recycle batteries in accordance with local
recycling procedures.
17
Advertisement
Table of Contents
