Table of Contents
Advertisement
AIR300 LEG EXTENSION PRO
OPERATION MANUAL
BATTERY REPLACEMENT
Do not operate the equipment during battery replacement procedure. "Lo-bA" = Batteries are low, replace immediately.
NOTE: If batteries are dead (depleted), the Power Display remains blank. To replace the batteries, refer to Figure 10 and
follow the instructions below (no tools required).
1.
Unscrew the Brass Nut on the Processor Box.
Pull and remove the cover.
2. Remove the 2 D batteries by carefully pulling
out the Battery Sleeve (follow manufacturer's
recommendations for handling, maintaining,
and disposing of batteries).
3. Observe the correct polarity position (see +/-
marking inside the battery compartment),
insert the 2 new D batteries into the battery
sleeve and install.
4. Replace the Processor Box cover and screw
the Brass Nut finger tight.
When the batteries are replaced, the Power Display will run through a test sequence (you will see a series of numbers
flashing). Once the test sequence stops and the Power Display shows "OFF," the Air300 Leg Extension Pro is ready for use.
Do not dispose of batteries in a fire. The
batteries may explode.
Do not open or mutilate batteries. They
contain an electrolyte which is toxic and
harmful to the skin and eyes.
Batteries and Sleeve
Processor
Box Cover
Brass Nut
Figure 10. Battery Replacement
CAUTION
Replace batteries with the same number
and type of batteries as originally installed
in the equipment.
Recycle batteries in accordance with local
recycling procedures.
16
Advertisement
Table of Contents
