Maintenance; 18_Preventative Maintenance Schedule - Keiser M7i Installation And Operation Manual

M7i WHEELCHAIR-ACCESSIBLE TOTAL BODY TRAINER

MAINTENANCE

CAUTION: Routine maintenance is an essential part of maintaining the highest level of equipment safety, as
well as optimal equipment performance. Immediately replace damaged, worn, or broken parts and do not use
the M7i until all repairs have been completed and tested by a certified Keiser technician.
PREVENTATIVE MAINTENANCE SCHEDULE
Weekly
1st Month
Monthly
Biannually
Contact Keiser Customer Support for replacement part(s) order, or for any matters regarding the safe operation of
your M7i, by telephone at 1 559 256 8000, online 24/7 at keiser.com/support, or by email at service@keiser.com.
• Check to ensure that the M7i is in safe proper working order:
–
M7i is leveled (refer to page 11, "Leveler Foot" section).
–
Handles operate properly, (refer to page 12, "Adjustment Knobs" section).
• Check that parts most susceptible to wear are not damaged or broken:
–
Handles, Grips, Adjustment Knobs, Recoiler Safety Straps, Footpads, and Foot
Straps.
• Wipe all areas in the sweat path with a dry soft towel or cloth.
• Check to ensure all external visible screws and nuts are not loose and that they
are fastened tight.
• Check for broken stitches or parts; torn, cut or frayed material; or locks, buckles,
or hook and loop fasteners that do not hold securely.
• Clean external surfaces using warm soapy water and a soft cloth, especially around
the areas that come in contact with sweat.
–
Do not use household or industrial cleaners as they can destroy the paint finish.
–
For deeper cleaning, use only mild dish washing soap, followed by an automotive
treatment such as Meguiar's
• Check to ensure all external visible screws and nuts are not loose and that they
are fastened tight.
• Check Handles, Grips, Adjustment Knobs, Recoiler Safety Straps, Footpads, and
Foot Straps and replace if worn.
• The low battery signal ("LO-BA") will appear on the computer display when it is
time to replace the batteries (two D batteries per M7i, refer to "Computer Battery
Replacement" on page 19 for complete instructions).
NOTE: For establishments with multiple M7i machines, replacement of all computer
batteries at the same time is recommended.
• Apply wax to protect the paint finish on metal parts:
1. Wipe down and thoroughly clean the M7i prior to applying wax.
2. Use an easily applied automotive treatment such as Meguiar's
and Wipe.
3. Target areas that come in contact with sweat as they are most vulnerable to rust.
NOTE: Failure to apply a coat of wax to high-sweat areas at least twice annually
will decrease paint and frame life due to corrosion and will void the warranty.
• Apply lubricant to the Adjustment Knobs:
1. Unscrew Adjustment Knobs from the Arm.
2. Clean threads with a lint-free cloth.
3. Apply a moderate amount of lubricant to the threads.
NOTE: Both the threaded stud and the threaded insert nut are stainless steel. It
is critical to keep the threads lubricated with a heavy grease (preferably white or
clear in color), such as HYDROTEX
anti-wear and corrosion resistant properties.
Quik Detailer Mist and Wipe.
®
Acculube #2 or any compound with equivalent
®
18
Quik Detailer Mist
®