Table of Contents
Advertisement
PERFORMANCE TRAINER | OPERATION MANUAL
MAINTENANCE
CAUTION: SERVICE AND REPAIR SHALL ONLY BE PERFORMED BY KEISER-CERTIFIED TECHNICIANS.
Failure to follow these instructions can result in serious injury.
PREVENTATIVE MAINTENANCE SCHEDULE
CAUTION: THE HIGHEST LEVEL OF EQUIPMENT SAFETY CAN ONLY BE ENSURED IF EQUIPMENT IS
REGULARLY INSPECTED FOR DAMAGE AND WEAR. Always check equipment is securely fastened to the
Wall Mount Tubes and wall before use (no tilt, lean, or any other movement of the unit should be detected during
use). Immediately replace damaged, worn, or broken parts. Do not use the Performance Trainer until all repairs
have been completed and tested by a Keiser-certified technician.
Daily
Weekly
Monthly
Quarterly
Annually and
other Required
Maintenance
IMPORTANT: Do not use household or industrial cleaners as they contain caustic chemicals that can destroy the paint
finish and cause corrosion. Use only mild detergent (neutral, non-caustic) to clean.
Contact Keiser Customer Support for replacement parts order, or for any matters regarding the safe operation of your
Performance Trainer (see back cover for contact information).
•
Wipe down the external body/parts using a moist cloth and a mild detergent (neutral,
non-caustic). Wipe dry the machine to prevent corrosion.
•
Check that parts most susceptible to wear are not damaged or broken:
– Pulleys, Cable, Speed Clip, Handle, Thumb Buttons, and Adjustment Plunger.
•
Check to ensure that the Performance Trainer is in safe and proper working order:
– The Performance Trainer is securely fastened to the Mount Tubes and wall. There
should be no movement of the unit in any direction during use.
– Press the "+" and then "-" Thumb Buttons a few times to ensure air cycles
through and that the Power Display powers on.
– Cable travels freely and smoothly without binding.
•
Hand wash the strap material of accessories using mild detergent (neutral, non-caustic)
and water. Air dry only.
•
Clean chrome and paint with a damp soft towel or cloth, then dry.
•
Apply wax to the chrome to protect the finish:
1.
Wipe down and thoroughly clean the Performance Trainer prior to applying wax.
2. Use an easily applied automotive treatment such as Meguiar's
and Wipe*.
NOTE: Failure to apply a coat of wax to high-sweat areas will decrease chrome life
due to corrosion and will void the warranty.
•
Inspect Air Line for kinks, tears, or breaks.
•
Clean the external body/parts thoroughly, targeting areas that come in contact with
sweat, using a moist cloth and a mild detergent (neutral, non-caustic). Wipe dry the
equipment.
•
Check all mount hardware (bolts/nuts) and externally visible screws are fastened with
no looseness. There should be no movement of the unit in any direction during use.
•
For complete instructions, see page 18 "Annual Maintenance."
•
Battery Replacement. The low battery signal ("Lo-bA") will appear on the Power Display
when it is time to replace the batteries. Refer to page 17 "Battery Replacement" for
complete instructions.
For establishments with multiple Performance Trainer machines, replacement of all
Power Display batteries at the same time is recommended.
NOTE: Your Keiser Air Compressor (not included with your Performance Trainer) requires basic
annual maintenance. For complete Keiser Air Compressor maintenance instructions, download the
user manual at keiser.com/support (search: Air Compressor manuals).
16
Quik Detailer Mist
®
Advertisement
Table of Contents
