Pyronix EURO 46 APP Programming Reference Manual page 14

0020 Exit Starts All
0021 Exit Starts Any
0022 Final Set Any
0023 Strobe Set Fail
0025 Keyswitch Unset
0026 Set with Omit
0028 Power Fault
0029 Confirm Intruder
Any
0030 Confirm HU Any
0031 Entry
0032 Exit
0033 Entry / Exit
0034 Lights
0035 Follow Input
0036 Shunt Fault
0037 Restore 1
0038 Restore 2
0039 PIR Latch 1
0040 PIR Latch 2
0041 Mains Good
0042 Detr Indn Enable
0043 Follow Test
0044 Off During Test
0048 Detr Walk Test
0049 Detector Masked
0050 Follow 24 Hour
At the start of the exit time to set the
LAST area.
When the exit time starts to set the FIRST
area.
When ANY area has been set.
Works similar to output 016, but also fires if the 'set fail' timer expires.
This output turns on for five seconds when the system is disarmed via a
keyswitch input (pulsed or latched).
Active when the system is set with an input omitted.
Active during low volts and battery faults. Restores at code entry after the fault
is cleared.
When more than one intruder alarm
activates.
When more than one confirmed HU
activates.
Active during any entry time.
Active during any exit time.
Active during any entry or exit time.
When the exit or entry timer starts.
Active when a specific input number has been activated. It allows the following
options to be programmed:
- Follow Type (Follow, Timed, Latched, Code Reset);
- Follow What (Input, Shunt List, Sub-Area, Area);
- Follow When (Always, When Armed, When Disarmed);
- Input to Follow
After an input in the shunt list is opened with an active detector (attempting to
unshunt) the 'Shunt Fault' output pulses until the shunt is reset.
At code entry to set. The normal state of
this input is 0v and it changes to 12v
when activated.
Activates whenever an additional area is
set. The normal state of this input is 0v
and it changes to 12v when activated.
When set (and in Walk Test).
This is the inverse polarity to
PIR Latch 1.
Output showing the 230v mains supply is present.
Output activates during walk test and also when a code is entered to view
detector indications (staying activated for the time that indications are viewed).
Output will activate only when tested from the Engineer menu 'Test Outputs' in
the 'Engineer Tests'. This output can be used as an additional facility for testing
the operation of a Bell. An output programmed to one of these configurations (43
and 44) may be used to trigger a relay to break the hold-off connection to the
Bell – or even to provide the hold-off directly.
Output is normally active and will deactivate only when tested from the Engineer
menu 'Test Outputs' in the 'Engineer Tests' (the same as 43 but opposite
activation).
This output is active during walk test and will only deactivate when all detectors
have been tested.
If any detector goes into 'mask' condition
the output will activate.
If any input programmed as '24 Hour'
activates.
Page: 14
At unset FIRST area (such as no
longer fully set).
At code entry to unset LAST area.
At code entry to unset LAST area.
At next code entry.
At the next code entry.
20 seconds after the set/unset
procedure has completed.
After three seconds.
When unset,
At alarm, or when unset.
At alarm, or when unset.
When the masking fault clears.
When the input is restored.