DeLaval VMS 2008 Instruction Book page 135

5
6
7
2007-12-18
DeLaval voluntary milking system VMS
Maintenance
5. Remove the handle out of the liner and
through the hole of the teatcup. Make sure
that the metal rope lock is above the edge
of the teatcup. Pull the handle smoothly but
in one movement in an angle of 0 - 45
degrees until the liner is in the right position.
Note: Do not pull the handle straight up.
6. Check that the liner is installed as shown
in the picture.
7. Use the pipe tool to insert the connector
pipe.
94897201.pdf
127(198)