Chapter 2: Installation
2. Lightly push the DIN-Rail into the track.
Figure
2-12:
DIN-Rail mounting
3. Check if the DIN-Rail is tightened on the track or not.
4. To remove the industrial switch from the track, reverse above steps.
Wall Mount Plate Mounting
Follow the steps below to mount the Industrial Switch with wall mount plate.
1. Remove the DIN-Rail from the Industrial Switch; loose the screws to remove the
DIN-Rail.
2. Place the wall mount plate on the rear panel of the Industrial Switch.
3. Use the screws to screw the wall mount plate on the Industrial Switch.
4. Use the hook holes at the corners of the wall mount plate to hang the Industrial
Switch on the wall.
5. To remove the wall mount plate, reverse the above steps.
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
25