Connecting the inlet hose
NOTICE
Risk of damage!
The dishwasher is designed for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa, 40 to 100 N/cm²). Water
must always be able to run freely into
the dishwasher, otherwise this can
damage the appliance.
If the water pressure is higher than
■
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
Never connect the appliance to the
■
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
Ensure that the inlet hose is not
■
kinked and is carefully connected.
Do not cut through the inlet hose.
■
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist ("Service" see
page EN-31).
Do not use old or previously installed
■
inlet hoses.
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
Installation, connection and initial commissioning
2. Check that the connection to the water
Connecting the mains plug
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
■
Fire hazard!
■
Requirements:
– A qualified professional must install an
– The socket must be installed in such a way
– Do not use a multi-socket extension cable,
– We recommend using a pulse-sensitive re-
• Connect the mains plug to the socket.
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping
from the connection. Then close the valve
again.
WARNING!
Prior to connecting the dishwasher,
ensure that you have page EN-6 tak-
en note of all the safety instructions
and adhered to them.
Never use multi-socket adapters,
multi-socket strips, travel adapters or
the like.
earthed power socket with its own fuse of a
sufficient size (220 - 240 V~ / 50 Hz / 10 A).
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
multi-socket plug, travel adapter, extension
cable or similar.
sidual current device (RCD).
Page EN-23