Assigning a Password
If no password has been assigned, the following appears:
ENTER PASSWORD?
(Y/N)
If a password has already been assigned for the current programming menu, the "ENTER
PASSWORD?" prompt is replaced by the following:
CHG PASSWORD?
[Y/N]
ENTER PASSWORD:
VERIFY PASSWORD:
When the password question(s) have been answered, the system exits program mode and
returns to normal mode. You can then disconnect the programming tool, or use it to trigger
test messages. Refer to "Testing the Installation" paragraph in Section 4.
Passwords can be used to split the programming
questions into two menus. Refer to the "Password
Protection" paragraph earlier in this section. If a
password is desired, press [Y]. The following prompts
appear. Press [N] if no password is desired.
Press [Y] if you want to change the password for the
current programming menu. If [Y]es is pressed, you are
prompted to enter the new password twice (as
confirmation).
To clear an existing password, answer [Y] to the "CHG
PASSWORD" prompt, then press the [Enter] key when
prompted for the new password and its confirmation.
Press [N] if you do not want to change the password for
the current programming menu.
Enter the 4-digit password.
Re-enter the 4-digit password as confirmation.
Section 5: 7845CZ Installation
5–11