Password Protection; Table 6. 7720P Normal And Shift Key (Shift Led Lit) Functions - ADEMCO 7845CZ Installation And Setup Manual

Seven zone cellular control channel transceiver

Hide thumbs

Table Of Contents

Table of Contents

Table 6. 7720P Normal and Shift Key (shift LED lit) Functions

KEY

BS/ESC

[BS]: Press to delete entry

↓/↑

[↓]: Scroll down programming

N/Y

[N]: Press for "NO" answer

SHIFT

Press before pressing a Shift key function. Will light Shift LED. LED goes out once a

key is pressed. Press again for each Shift function desired.

1/A

[1]: For entering the number 1

2/B

[2]: For entering the number 2

3/C

[3]: For entering the number 3

4/D

[4]: For entering the number 4

5/E

[5]: For entering the number 5

6/F

[6]: For entering the number 6

7/S

[7]: For entering the number 7

8/T

[8]: For entering the number 8

9/X

[9]: For entering the number 9

SPACE

[SPACE]: For scrolling option list

[0]: For entering the number 0

#/ENTER

[#/ENTER]: Press to accept entries

* Active only when the "REVIEW?" prompt is displayed.

After connecting the 7720P cable, power up the 7845CZ. The following is displayed:

x.xx = current software revision level

At this prompt during initial power-up, you may proceed with programming the 7845CZ.

Programming is accomplished by answering displayed questions. Most questions require

only a [Y]es or [N]o response, while others require a numerical response (ID numbers, etc.).

Press the [ENTER] key to accept each response and proceed to the next question. A "?"

displayed indicates an invalid entry. The current value is displayed on the second line in

parentheses ( ). To accept the current entry, press the [ENTER] key. If the current value is

an invalid entry, pressing the [ENTER] key causes the display to repeat the unanswered

question; the next question is not displayed until a valid answer is entered. Use the up/down

arrow keys to scroll through the programming questions without changing any values. Press

the [ESC] key to go to the end of the list of questions.

Enter programming mode by pressing [ENTER] during the initial power-up period after

the chaser sequence (while radio status LEDs are blinking consecutively or in unison).

The 7845CZ reads its EEROM to determine its preprogrammed parameters. A CRC of the

EEROM locations is also read. If the computed CRC does not match the one read from

EEROM, or if the programming parameters are invalid, the 7720P LCD displays "NO PROG"

and the radio status LEDs blink in unison (after the initial chaser sequence). Otherwise, the

LEDs blink consecutively.