7845CZ Installation and Setup Guide
4. Contact AlarmNet (TAC) to Register 7845CZ
NOTE: Programmerless registration CANNOT be performed on replacement
radios. A 7720P Programming Tool is necessary. Refer to Section 5 to replace a
radio.
• Call the AlarmNet Technical Center (1-800-222-6525) to walk through the registration
process.
• Have the following information ready BEFORE calling by filling in the table below:
The radio's MIN located on the barcode label on the radio module.
The subscriber number (as provided by the central station). This number should include a 2-digit city
number, a 2-digit central station number, and a 4-digit subscriber ID.
The time zone in which the radio is to be installed.
MIN
CITY CODE
CS ID
SUBSCRIBER ID
TIME ZONE
• The AlarmNet personnel will first determine if the subscriber number provided is valid.
If the number is not valid, the central station must provide a new number.
• If the number is valid, the registration process can be initiated by "triple-clicking" the
tamper switch. The AlarmNet personnel will walk through the LED progression as
shown below.
G
Y
R
"click"
"click"
"click"
• When the green LED goes out, the radio is registered and alarm traffic will be sent to the
central station.
5. Complete the Installation
• Mount the radio (refer to "Mounting and Wiring").
• Wire to the control panel (refer to "Mounting and Wiring") and test all signals.
• Test the installation (refer to the "Testing the Installation" paragraph in Section 4).
3–2
MSG 1
MSG 2
MSG 3
WAIT
S E N T
S E N T
S E N T
ACK
Y
G
G
G
Y
Y
G
G
G
Y
Y
G
G
G
Y
Y
Y
G
G
R E G I S T R A T I O N
registration
progress
G
blink rapid
on
off
blink
LED Key