Table of Contents
Advertisement
PROGRAMMING
THE 7920SE
PASSWORD PROTECTION
Both the Central Station setup menu and the Subscriber setup menu can be
programmed for password protection, if desired, and each of these menus can
be assigned
a different
password, which provides additional security.
Passwords are programmed using the Central Station Setup Menu. Upon
entering this menu (pressing "C" within 8 seconds of power up or "X" key
reset), and answering the "7720 P(Y/N)" question, this series of questions
appears:
SELECT 1 OR 21
I
I PWRD 1
I
NU PWRD DISCRD
9
I
Press "Y" to assign a password for either the
Subscriber or Central Station menus.
If "N" is
pressed, the display goes directly to the current
parameters
display shown
in the
"CENTRAL
STATION SETUP MENU" section. If "Y" is pressed,
the following is displayed:
Press "1" to assign a password for the subscriber
menu. Press "2" to assign a password for the
central station programming menu.
NOTE
The 7720P Programming Tool is limited to
A thru F, S, T and X characters, Use a terminal or
laptop if you need to use characters not available
with the 7720P.
Enter any four characters (must be four characters)
and press RETURN. Note that the characters are
not displayed while typing.
Reenter the same four characters.
[f the new
characters
do
not
match
the
first
entered
characters, the following is displayed:
The characters entered did not match the first
entered characters. Enter the password characters
desired and press RETURN. The VERIFY message
will again be displayed.
Press W" to install the new password. Press "N" if
the enby is to be discarded. The screen displays
When password programming is completed, the
screen displays the current system parameters with
the CHNG OPT (Y/N) question.
Refer to the
"CENTRAL STATION SETUP MENU" section for
Central Station programming instructions.
-11-
Advertisement
Table of Contents
