Table 1. 7720P Programming Tool Keyboard Commands - ADEMCO 7845CZ Installation And Setup Manual

7845CZ Installation and Setup Guide

Table 1. 7720P Programming Tool Keyboard Commands

COMMAND
A
B
C
D
E
F
S
T
X
↑
↓
4. Program the Radio
• Determine how the input zones will be used.
• Connect the 7720P Programming Tool; reset the radio by cycling the power off, then on;
press [Enter] during the initial power-up sequence to enter Programming mode.
• Program the 7845CZ as described in the Programming section.
5. Register the Radio
• Send test registration with the 7720P [T] command to verify account and routing.
• Register the 7845CZ with AlarmNet by triple-clicking the tamper switch and observing
the LED displays as shown below, or by pressing the [↑] key on the 7720P.
G
Y
R
"click"
"click"
"click"
6. Complete the Installation
• Mount the radio (refer to "Mounting and Wiring").
• Wire to the control panel (refer to "Mounting and Wiring") and test all signals.
• Test the installation (refer to the "Testing the Installation" paragraph in Section 4).
2–2
Software revision
Radio and connectivity display (network OK, no service, no contact, signal
strength, A or B carrier, MIN)
Network time display
Battery test (starts 10-minute battery test)
Network system display (channel, local carrier, SID)
Carrier display (A or B carrier, MicroBurst found, preferred side indication)
Status display
Test signal/Test registration when unregistered
Reset
Register radio (must be programmed)
Replacement radio (must have PIN)
MSG 1 MSG 2 MSG 3 W A I T
S E N T S E N T S E N T A C K
Y G G G
Y
Y G G G
Y
Y Y G G G
Y
FUNCTION
R E G I S T R A T I O N
registration
progress
Y G G G
on
off blink rapid
blink
LED Key