Telco Channel And Open/Close Zone (Questions 39-40); Redundant Central Station Reporting (Questions 41-53) - ADEMCO 7845CZ Installation And Setup Manual

Question 35.
Restore Zn4 Y/N)
Question 36.
Restore Zn5 Y/N)
Question 37.
Restore Zn6 Y/N)
NOTE: If Arm/Disarm feature is enabled, skip to Question 39.
Question 38.
Restore Zn7 Y/N)

Telco Channel and Open/Close Zone (Questions 39-40)

Question 39.
Telco Chan
(00)
Question 40.
Open Close Zone
(00)

Redundant Central Station Reporting (Questions 41-53)

Question 41.
2nd CS (Y/N)
Question 42.
2CS Zone 1 (Y/N)
Question 43.
2CS Zone 2 (Y/N)
Question 44.
2CS Zone 3 (Y/N)
Question 45.
2CS Zone 4 (Y/N)
Press [Y] to report restores on zone 4.
Press [N] to disable restoral reporting on zone 4.
Press [Y] to report restores on zone 5.
Press [N] to disable restoral reporting on zone 5.
Press [Y] to report restores on zone 6.
Press [N] to disable restoral reporting on zone 6.
Press [Y] to report restores on zone 7.
Press [N] to disable restoral reporting on zone 7.
Enter the physical telco line fault zone.
Zones 1 and 2 CANNOT be used.
If the Lynx Panic feature is enabled, Zone 3 cannot be used.
If the Arm/Disarm feature is enabled, Zone 7 cannot be
used.
A [0] entry disables telco detection.
Enter the open/close reporting zone number.
Zones 1 and 2 CANNOT be used.
If the Lynx Panic feature is enabled, Zone 3 cannot be used.
If the Arm/Disarm feature is enabled, Zone 7 cannot be
used.
A [0] entry disables open/close reporting.
If this zone selection is the same as the telco zone, the
displayed value will appear as "??". The two entries must
be unique.
Press [Y] if redundant reporting to a second central station
is desired.
Press [N] if not desired (skip to end).
Press [Y] to enable reporting to second central station for
zone 1.
Press [N] to disable reporting.
Press [Y] to enable reporting to second central station for
zone 2.
Press [N] to disable reporting.
Press [Y] to enable reporting to second central station for
zone 3.
Press [N] to disable reporting.
Press [Y] to enable reporting to second central station for
zone 4.
Press [N] to disable reporting.
Section 5: 7845CZ Installation
5–9