Arm/Disarm Section (Questions 20-26) - ADEMCO 7845CZ Installation And Setup Manual

Question 15.
Invert Zn3 (Y/N)
Question 16.
Invert Zn4 (Y/N)
Question 17.
Invert Zn5 (Y/N)
Question 18.
Invert Zn6 (Y/N)
Question 19.
Invert Zn7 (Y/N)

Arm/Disarm Section (Questions 20-26)

Question 20.
Arm/Dis En (Y/N)
Question 21.
Enable Z1 on arm
Question 22.
Enable Z2 on arm
Question 23.
Enable Z3 on arm
Question 24.
Enable Z4 on arm
Question 25.
Enable Z5 on arm
Press [Y] if Zone 3 is to be triggered by removal of voltage.
Press [N] for normal input signal.
Press [Y] if Zone 4 is to be triggered by removal of voltage.
Press [N] for normal input signal.
Press [Y] if Zone 5 is to be triggered by removal of voltage.
Press [N] for normal input signal.
Press [Y] if Zone 6 is to be triggered by removal of voltage.
Press [N] for normal input signal.
Press [Y] if Zone 7 is to be triggered by removal of voltage.
Press [N] for normal input signal.
This feature enables users to limit alarm traffic when the
system is disarmed.
Press [Y] to designate Zone 7 as the arm/disarm zone; this
can be used to determine whether alarm reports of chosen
zones are transmitted. See Questions 20 through 26 to
choose reporting zones. The chosen zones are reported
ONLY when the system is "armed". The system is
considered "armed" when the voltage is applied to the
arm/disarm zone. Otherwise, the system is disarmed.
Press [N] to disable the arm/disarm feature; skip to
Question 27.
Press [Y] to report alarms on zone 1 ONLY when the
system is armed.
Press [N] to report alarms on zone 1 regardless of system
state.
Press [Y] to report alarms on zone 2 ONLY when the
system is armed.
Press [N] to report alarms on zone 2 regardless of system
state.
Press [Y] to report alarms on zone 3 ONLY when the
system is armed.
Press [N] to report alarms on zone 3 regardless of system
state.
Press [Y] to report alarms on zone 4 ONLY when the
system is armed.
Press [N] to report alarms on zone 4 regardless of system
state.
Press [Y] to report alarms on zone 5 ONLY when the
system is armed.
Press [N] to report alarms on zone 5 regardless of system
state.
Section 5: 7845CZ Installation
5–7