Assa Abloy Sargent PASSPORT 1000 P1 Installation Instructions Manual page 19

Passport 1000 P1 PoE Mortise Lock
11 Install Inside Module Component Assembly
1. Insert top tabs of controller into slots on mounting plate (Fig. 11A).
2. Ensure proper alignment of board-to-board connectors while pivoting
bottom of controller toward door until tab on bottom snaps securely
into place on mounting plate.
CAUTION: To avoid possible damage to board-to-board connec-
tors, care should be taken when securing controller to mounting
plate. If there is resistance when securing, detach controller to de-
termine cause before re-attaching controller.
Fig. 11A
3. Connect RJ45 male Connector to female RJ45 on controller board
(Fig. 11B, C).
4. Remove pull tab from its position beneath the coin cell by pulling on
tab in direction of arrows printed on tab (Fig. 11B, C).
Fig. 11B
Fig. 11C
1-800-810-WIRE • www.sargentlock.com • A8032G
Coin Cell
Pull Tab
Coin Cell
Pull Tab
19