Assa Abloy Sargent PASSPORT 1000 P1 Installation Instructions Manual page 13

Passport 1000 P1 PoE Mortise Lock
3 Install Lock Body
Note: Do not pull the lock into the pocket using the harness alone.
Ensure that the wire harness is not pinched between the lock and the mortise pocket.
1. Feed the wire harness into the mortise pocket and
through inside preparation hole as depicted in Figure 3.
2. Carefully push the lock body into the pocket while
lightly applying tension to the wire harness.
3. Insert (2) #12-24 screws into the lock body (Fig.4)
and partially tighten* with a screw driver.
*Do not fully tighten until cylinder and levers
are installed and properly aligned.
(2) #12-24
screws
Ground
Wire
Wire
Harness
1-800-810-WIRE • www.sargentlock.com • A8032G
Inside of Door
Cat 5e cable
from hinge
Fig. 3
13