The ambient temperature during the charging
process must be within the range from 0 °C to
40 °C.
The battery can remain on the pedelec or can be
removed for charging.
Interrupting the charging process does not
damage the battery.
If pedelec features two batteries, charging for
both batteries is started via pannier rack battery.
Remove the rubber cover from the battery.
Connect the mains plug of the charger to a
normal domestic, grounded socket.
Connection data
Notice
Check that mains voltage is correct. The
power source voltage must match the voltage
indicated on the charger nameplate. Chargers
labelled 230 V may also be operated at 220 V.
Connect the charging cable to the battery's
charging port.
The charging process starts automatically.
The battery level indicator shows the charge
level during charging. When the drive system is
switched on, the display screen shows the
charging process.
Disconnect the battery from the charger and allow
it to cool down. Do not connect the rechargeable
battery to the charger again until the permitted
charging temperature has been reached.
The charging process is complete when the
LEDs on the operating status and battery level
indicator go out.
Once charging is complete, disconnect the
battery from the charger and the charger from
the mains.
MY20B01-22_1.0_21.06.2019
230 V, 50 Hz
If the battery is outside
its charging
temperature range,
three LEDs will flash on
the battery level
indicator
6.9.5
Charging the dual battery
Only applies to pedelecs with this equipment
One of the charging sockets is not accessible or is
closed with an end cap on Pedelecs with two
batteries.
Notice
Charge the battery via the accessible charging
socket only.
Never open a closed charging socket.
Charging via a pre-closed charging socket can
cause irreparable damage
Figure 71: Covering open contacts with cover cap –
example: pannier rack battery
(1) If you wish to battery use just one battery on
a pedelec which is designed for two batteries,
cover the contacts on the free slot with the
supplied cover cap; otherwise, there is a risk of
a short circuit caused by the open contacts.
6.9.5.1 Charging process when two batteries
are used
If two batteries are attached to a pedelec,
charge the two batteries via the non-closed
socket.
The two batteries are charged alternately
during the charging process. Charging
switches automatically between the two
batteries several times. The charging time is
twice as long.
The two batteries are discharged alternately
during use.
Operation
(1)
73