You will find how to switch from automatic to
manual mode, depending on the shifter used,
described in your operating instructions for your
gear shift.
If you use the shifter when in automatic mode, the
gear system will change to the next gear, but it will
remain in automatic mode.
Manual gear changes in automatic mode
influence shift behaviour in your gear system and
adjust gear changes to your riding performance
since it is a self-learning system.
If the system is switched on for the first time when
a new, unused wheel is used, the system will learn
the gears first. To do so, the automatic system
changes to the highest/most difficult gear and
then switches through all gears during the first
ride. The new gear is shown briefly on the screen
each time it is changed.
Since the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is also possible to switch gears under load or on
hills.
If the pedelec is brought to a halt from a speed
greater than 10 km, the system can automatically
switch back to a pre-set S TA R T G E AR .
You can set the S T AR T G E A R in the system
settings.
6.13.3.2
eShift with manual Shimano DI2
hub gears
Only applies to pedelecs with this equipment
The new gear is shown briefly on the screen each
time it is changed.
Since the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is also possible to switch gears under load or on
hills.
If the pedelec is brought to a halt from a speed
greater than 10 km, the system can automatically
switch back to a pre-set S TA R T G E AR .
You can set the S T AR T G E A R in the system
settings.
MY20B01-22_1.0_21.06.2019
6.13.3.3
eShift with Shimano DI2 automatic
hub gears
Only applies to pedelecs with this equipment
The new gear is shown briefly on the screen each
time it is changed. Since the drive unit detects the
gear shift and consequently reduces motor
assistance briefly, it is also possible to switch
gears under load or on hills.
6.13.3.4
eShift with NuVinci H|Sync/enviolo
with Optimized H|Sync
Only applies to pedelecs with this equipment
N U V I NC I C A D E N C E mode allows you to
reduce or increase the desired pedalling
frequency using the plus button or minus button
on the control panel.
If you hold the plus button or minus button down,
you can increase or reduce the pedalling
frequency in increments of five. The desired
pedalling frequency is displayed on the screen.
N U V I NC I G EA R mode allows you to switch
between several specified transmissions using
the plus button or minus button on the control
panel. The selected transmission (gear) is
displayed on the screen.
6.13.3.5
eShift with Rohloff E-14 Speedhub
500/14
Only applies to pedelecs with this equipment
The new gear is shown briefly on the screen each
time it is changed.
Since the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is also possible to switch gears under load or on
hills.
If the pedelec is brought to a halt from a speed
greater than 10 km/h, the system can
automatically switch back to a pre-set S T A R T
G E A R .
You can set the S T AR T G E A R in the system
settings.
Operation
88