Removing and attaching the
6.10.5.3
display
Notice
If the rider is not present, the display can be used
without authorisation, e.g. it may be stolen, the
system settings may be changed or journey
information may be read.
Remove the display when the pedelec is parked.
6.10.5.4
Removing the display
Take hold of the display at its top end.
Pull the display forwards away from the
contacts to the drive unit until it is released
from its magnetic mount.
The system is switched off by removing the
display.
.
3
4
Figure 72: Pull the display (2) out of its mount (1) away
from the contacts with the display blocking screw (3).
6.10.5.5
Inserting the display
Place the display lower section onto the mount.
Fold the display gently forwards until it is
clearly fastened into the magnetic mount.
Notice
The display can be secured with a securing strap
(available as an option) to prevent it from falling
out of its mount in the event of a crash.
MY20B01-22_1.0_21.06.2019
6.10.5.6
The blocking screw does not offer protection
against theft.
Position the display in its mount.
Fasten the blocking screw (M3, 6 mm in
length) into the designated thread in the
display from below.
You may damage the display if you use a longer
screw.
6.10.5.7
A USB connection is not a waterproof plug
connection. Any moisture which enters through
2
the USB port may trigger a short circuit in the
display.
Never connect an external device when
cycling in the rain.
Always close the protective flap on the USB
port when cycling in the rain.
1
Regularly check the position of the rubber cover
on the USB port and adjust it as necessary.
Connected electrical loads may have an adverse
effect on the Pedelec range.
The USB port can be used to operate external
devices which can be connected using a standard
micro A/micro B USB 2.0 cable.
The display and a sufficiently charged battery
must be in place on pedelec to use the USB port.
Open protective flap on the USB port on the
display.
Connect the external device USB port with the
USB port on the on-board computer using a
micro A–micro B USB charging cable.
Replace the protective flap after using the USB
port.
Securing the display
Notice
Notice
Using the USB port
Notice
Operation
77