Switching On The Display; Switching Off The Display; Using The Push Assist System; Using The Riding Light - Bosch Bulls Cross Lite Evo Operating Instructions Manual

Table of Contents

Advertisement

6.10.6 Switching on the display

 Press the On-Off button (display) once.
 The electric drive system is switched on.

6.10.7 Switching off the display

CAUTION
!
Injury from pedals or wheels
The pedals and the drive wheel turn when the
push assist system is used. There is a risk of
injury if the pedelec wheels are not in contact with
the ground when the push assist system is used
(e.g. when carrying the pedelec up stairs or when
placing it on a bicycle rack).
 Only use the push assist mode when pushing
the pedelec.
 You must steer the pedelec securely with both
hands when using push assist.
 Allow for enough freedom of movement for the
pedals.
If the display is not inserted into the mount, it will
switch off automatically after one minute to save
energy if no button is pressed.
 Press the On-Off button (display) once.
 The electric drive system is switched off.

6.10.8 Using the push assist system

The push assist helps the rider to push the
pedelec. The speed can be a maximum of 6 km/h
in this case.
The tractive power of the push assist and its
speed can be influenced by the selection of gear.
To spare the drive, first gear is recommended for
travelling uphill.
The level of assistance OFF must not be selected.
 Press the push assist button once to activate
the push assist.
 Press and hold down the plus button on the
control panel within 3 seconds to switch on the
push assist.
 Release the plus button on the control panel to
shut off the push assist. The push assist
system switches off automatically as soon as
the pedelec wheels are blocked or the speed
exceeds 6 km/h.
MY20B01-22_1.0_21.06.2019

6.10.9 Using the riding light

The drive system needs to be already switched
on to turn on the riding light.
 Press the riding light button on the display.
 The front light and rear light are both switched
on (riding light symbol is displayed) or switched
off (riding light symbol is not displayed) at the
same time.

6.10.10 Selecting the level of assistance

You can adjust how strongly the electric drive
should assist you on the control panel when
pedalling. You can change the level of assistance
at any time, even when you are cycling.
 Press the plus button on the control panel to
increase the level of assistance.
 Press the minus button on the control panel to
reduce the level of assistance.
 The motor power used appears on the screen.
The maximum motor power depends on the
selected level for assistance.
If the on-board computer is removed from its
mount (5), the last displayed level of
assistance is saved.

6.10.11 Operating the display

All user interface screens and texts on the
following pages correspond to the software's
release version. This means that there may be
slight changes to user interface screens and texts
if there are several updates to the software during
a year.
The display is operated using five buttons on the
control panel.
4
5
Figure 73: Control panel overview
Operation
3
2
1
6
78

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents