Installing The Wheel With A Quick Release; Axle; Force - Bosch Bulls Cross Lite Evo Operating Instructions Manual

5.3.2.3 Installing the wheel with a quick release

axle

CAUTION
!
Crash caused by loose quick release axle
A faulty or incorrectly installed quick release axle
may become caught in the brake disc and block
the wheel. This will cause a crash.
 Never fit a defective quick release axle.
Crash caused by faulty or incorrectly
installed quick release axle
The brake disc becomes very hot during
operation. Parts of the quick release axle may
become damaged as a result. The quick release
axle becomes loose. This will cause a crash with
injuries.
 The quick release axle and the brake disc
must be opposite one another.
CAUTION
!
Crash caused by incorrectly set quick release
axle
Insufficient clamping force will cause a
detrimental transmission of force. The
suspension fork or the quick release axle may
break. This will cause a crash with injuries.
 Never fasten a quick release axle with a tool,
such as a hammer or pliers.
 Insert the axle into the hub on the drive side.
Clamping version II.
Figure 32: Pushing the axle into the hub
MY20B01-22_1.0_21.06.2019
 Tighten the axle with the red handle.
Figure 33: Tightening the axle
 Push the quick release lever into the axle.
Figure 34: Pushing the quick release lever into the axle
 Reverse the quick release lever.
 The lever is secured.
Figure 35: Securing the lever
Assembly
45