Control Panel With Display; Charging The Display Rechargeable Battery; Charging The Display Battery On Pedelec; Charging The Display Rechargeable Battery Via The Usb Port - Bosch Bulls Cross Lite Evo Operating Instructions Manual

Table of Contents

Advertisement

6.10.3 Control panel with display

CAUTION
!
Crash caused by distraction
A lack of concentration while riding increases the
risk of an accident. This may cause a crash with
serious injuries.
 Never allow yourself to be distracted by the
display.
 Stop pedelec if you want to make inputs on the
display other than a change in level of
assistance. Only enter data when the bicycle
is stationary.
Notice
 Do not use the display as a handle. You may
irreparably damage the display if you use it to
lift the pedelec.
 If you do not use your pedelec for several
weeks, remove the display from its mount.
Store the display safely at room temperature in
a dry environment.
The display battery discharges when it is not in
use. This can cause irreparable damage to the
display battery.
 Recharge the display battery for at least
1 hour every 3 months.
6.10.4 Charging the display rechargeable
battery
You can recharge the display rechargeable
battery either on the pedelec or via the USB port.
6.10.4.1
Charging the display battery on
pedelec
Notice
The display will only charge when switched on.
 Switch the display on.
Note that the drive system will switch off
automatically after ten minutes if not activated if
you do not charge the pedelec rechargeable
battery immediately. The display battery will also
stop recharging in such a case.
MY20B01-22_1.0_21.06.2019
 Position the display in its mount.
 The charging process starts automatically.
6.10.4.2
Charging the display rechargeable
battery via the USB port
Notice
The display will only charge when switched on.
 Switch the display on.
If the display is switched off during recharging
with a USB cable, the display cannot be switched
on again until the USB cable has been
disconnected.
 Open the USB protective flap.
 Connect a standard USB charger (not included
in the standard scope of delivery) or the USB
port on a computer (5 V charge voltage; max.
500 mA charging current) to the display USB
port using a micro USB cable.
 The charging process starts automatically.

6.10.5 Storage mode

The display features a power-saving storage
mode, which minimises discharge from the display
rechargeable battery. The date and time are
eliminated during storage mode.
6.10.5.1

Activating the storage mode

The display will no longer start up when you press
the on-off button (display) once when in storage
mode.
 Keep the on-off button (display) pressed down
for at least 8 seconds.
 Storage mode is activated.
6.10.5.2
Deactivating the storage mode
 Press the on-off button (display) for at least
2 seconds.
 Storage mode is deactivated.
Operation
76

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents