Commissioning; Checking The Battery; Installing The Wheel In The Suntour Fork; Installing The Wheel With Screw-On Axle - Bosch Bulls Cross Lite Evo Operating Instructions Manual

5.3

Commissioning

CAUTION
!
Risk of fire and explosion due to incorrect
charger
Batteries which are recharged with an unsuitable
charger may become damaged internally. This
may result in fire or an explosion.
 Only ever use the battery with the supplied
charger.
 Mark the supplied charger clearly to prevent
mix-ups – with the pedelec frame number or
type number, for example.
Burns from hot drive
The drive cooler can become extremely hot
during use. Contact may cause burns.
 Leave the drive unit to cool before cleaning.
Only trained specialist staff may perform initial
commissioning since initial commissioning of the
pedelec requires special tools and specialist
knowledge.
Experience has shown that a pedelec which has
not yet been sold is automatically handed to end
users as soon as it appears ready to ride.
 For this reason, every pedelec must be
prepared, so that it is fully ready for use
immediately after being assembled.
 All assembly work described in the assembly
report (see appendix) must be performed to
ensure the pedelec is ready to ride. It
describes all safety-relevant inspections, tests
and maintenance tasks for the pedelec in a
separate list.
 Complete an assembly report for quality
assurance purposes.
MY20B01-22_1.0_21.06.2019
5.3.1

Checking the battery

WARNING
!
Risk of fire and explosion due to faulty battery
The safety electronics may fail if the battery is
damaged or faulty. The residual voltage can
cause a short circuit. The battery may self-ignite
and explode.
 Never charge a faulty battery.
The battery must be checked before it is charged
for the first time.
 Press the On-Off button (battery).
 If none of the LEDs on the battery level
indicator light up, the battery may be damaged.
 The battery may be fully charged if at least one,
but not all, of the LEDs on the battery level
indicator is lit up.
 Once the battery has been charged, insert it
into the pedelec.
5.3.2 Installing the wheel in the Suntour
fork
Only applies to pedelecs with this equipment

5.3.2.1 Installing the wheel with screw-on axle

(15 mm)

 Insert the axle completely on the drive side.
Figure 26: Fully inserting the axle
Assembly
43