Error Messages; Error Message Display - Bosch Bulls Cross Lite Evo Operating Instructions Manual

6.2

Error messages

6.2.1

Error message display

The drive system monitors itself continuously and
displays a number as an error message if a known
error is detected. The system may switch off
automatically depending on the type of error.
Code Description
One or more display
buttons are blocked
410
Connection problem with
414
the control panel
One or more buttons on
the control panel are
blocked
418
Configuration error
419
Connection problem with
422
the drive unit
Connection problem
423
Communication error with
components
424
communicating with one
another
Internal time-out error
426
Internal display battery flat
430
Software version error
431
Internal drive unit error
440
Internal software error
450
Error in USB port
460
Table 44: List of error messages
MY20B01-22_1.0_21.06.2019
Method of resolution

Check whether buttons are
jammed because dirt has got
into them, for example.
Clean the buttons if they
need cleaning.

Have ports and connections
checked.

Check whether buttons are
jammed because dirt has got
into them, for example.
Clean the buttons if they
need cleaning.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Have ports and connections
checked.

Have ports and connections
checked.

Have ports and connections
checked.

Re-start the system.

Contact your specialist
dealer if the problem
persists.
It is not possible to display or
adjust the tyre size in the
basic settings menu in this
error status.

Recharge internal display
battery (while in its mount or
using USB port).

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Re-start the system.

Contact your specialist
dealer if the problem
persists.
Code Description
490 Internal display error
Internal drive unit error
500
502
Fault in the lighting
System response to
detected tuning,
Sas Pedelec switches to
504
emergency ride mode and
logs the error
Speed sensor error
503
Internal sensor error
510
Internal drive unit error
511
Battery error
530
Configuration error
531
Temperature error
540
An inadmissible electrical
load has been detected
550
Software version error
580
Table 44: List of error messages
Operation
Method of resolution

Have display checked.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Check the light and its
cabling.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Can be reset for 90 minutes
by riding (possible 3 times)

If the error occurs again, the
specialist dealer will need to
set up the system again.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Turn off the drive system.

Remove the battery.

Insert the battery again.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

The pedelec is outside the
permitted temperature
range.

Switch the pedelec off to cool
the drive unit down or warm it
up to the permitted
temperature range.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Remove the electrical load.

Re-start the system.

Contact your specialist
dealer if the problem
persists.

Re-start the system.

Contact your specialist
dealer if the problem
persists.
52