Graco G3 Series Instructions Manual page 59

Cycle Control
• A set number of triggered counts in a cycle
based system (C1). Typically a proximity switch
connected to a divider valve.
• The LED next to the appropriate sensor (C/P1,
C/P2, C/P3) illuminates.
• The display indicates the sensor (C1, C2, C3)
and the remaining cycles for that sensor (F
48).
The example shown in F
with 5 cycles remaining.
HH MM SS
ON
MM : SS
C
1
P
C
C
2
P
C
P
3
P
F . 48
IG
332305J
. 48 shows sensor C1
IG
##
!
OFF
HH : MM
1 2 3
Pressure Control
A single triggered count in a pressure based
•
system (P1). Typically a pressure switch on the
end of a line of injectors.
• The LED next to the appropriate sensor (C/P1,
C/P2, C/P3) illuminates (F
• The display indicates the sensor (P1, P2, P3)
. and whether the pressure switch for that sensor
IG
has been triggered or not.
- 01 = pressure switch has not been triggered
- 00 = pressure switch is triggered.
The example shown in F
with a pressure switch that has been triggered.
F . 50 (page 60) shows sensor P2 with a pres-
IG
sure switch that has NOT been triggered.
HH
ON
MM : SS
C
1
P
C
2
P
C
3
P
F . 49
IG
. 49 and F
IG
. 49 shows sensor P1
IG
MM SS ##
!
OFF
HH : MM
C
1 2 3
P
Run Mode
. 50).
IG
59