Graco G3 Series Instructions Manual page 38

Max Model Setup
6. After pressing the ENTER button to set
the last MM field, the OFF Time informa-
tion is saved.
7. After selecting ON, refer to page 34.
NOTE: Backup time can be set in HH:MM for the
machine count input.
OFF Time
• The LED next to the clock in the OFF
field lights, indicating you are setting
the OFF Time parameters.
• OFF Time is set in Hours and Minutes
(HH: MM).
• An LED flashes under
either HH when pro-
gramming hours OR
MM when program-
ming minutes.
• In SETUP MODE the
number displayed in
the first field, on the
left side of display
blinks, indicating the
device is ready to pro-
gram the OFF Time hours.
• The total amount of OFF Time must be
at least twice as long as the pro-
grammed ON Time. If a value less
than twice the ON Time is entered, the
RED alarm LED lights and the value must be
updated.
If this time does not meet the application needs,
contact Graco Customer Support.
Programming OFF Time
NOTE: When programming a time of less than 10
hours you must program a leading zero in the first num-
ber field and press the ENTER button to save the zero
selection.
1. To set the OFF Time use the
UP or DOWN ARROW button
to scroll through numerals 0
to 9 until the desired number
appears in the first HH (hour)
field.
38
OR
2. Press the ENTER button to lock in the
selection. The next HH number field to
the right flashes indicating it is ready for
programming.
3. Use the UP or DOWN
ARROW button to scroll
through numerals 0 to 9 until
the desired number appears
in the second HH number
field.
4. Press the ENTER button to lock in the
selection.
The next number field to the right
flashes and the LED lights under MM; indicating it is
ready to program the minutes fields.
5. Repeat steps 1 - 4 to set the next MM (minutes)
fields.
6. After pressing the ENTER button to set
the last MM field, the OFF Time informa-
tion is saved.
Prelube
The Prelube function determines operation of the pump
when power is applied. It can be set to OFF or ON.
OFF (default) - The unit resumes its lubrication cycle at
the point it was at when power was removed.
ON - The unit begins a pump cycle.
Setting Prelube
1. After you set the OFF Time information and press
the ENTER button, the G3 automatically switches to
the Prelube Delay setup.
Notice the LED next to the prelube
icon on the G3 display lights indicat-
ing you are now in the Prelube setup
mode.
2. OFF displays. If you
want the prelube
cycle to begin imme-
diately, leave this set
to OFF.
3. Press the ENTER button to set the
selection.
332305J