Graco G3 Series Instructions Manual page 53

3. When the correct number displays,
press the ENTER button to set the num-
ber.
4. Repeat 2 - 3 to set the remaining fields.
5. Press the ENTER button to exit
Advanced Programming.
A5 - Active Alarm
Changes the alarm output behavior. Uses output to
determine if a fault has occurred.
Fault and ON LED's illuminate.
F . 37
IG
1. The default OFF dis-
plays.
2. Press the UP or DOWN
ARROW button to change
OFF to ON on the display to
activate alarm condition.
332305J
3. Press the ENTER button to exit
Advanced Programming.
A6 - Clearing the Functional and Technical
User Summary (DMS
The Pump Summary shows run details since the last
time the summary was cleared.
F . 38
IG
1. Press the UP or DOWN
ARROW button to move
through Advanced Options
until Advanced Option A6 is
displayed.
2. Press the ENTER button.
3. "Data" displays.
4. Press the RESET but-
ton. "Reset" displays.
The summary data is
cleared.
5. Press the RESET or
ENTER button to exit.
Advanced Programming
™
Models only)
53