Graco G3 Series Instructions Manual page 46

Operation / Data Log
Common Functional Summary Data entries are listed
below.
Number of Cycles
Total Run Hours
Total Powered On Hours
Local Manual Run
Remote Manual Run
Average Run Time
Average Cycle 1 Time
Average Cycle 2 Time
Average Cycle 3 Time
Average Duty Cycle
Max Duty Cycle
Total Low Level Faults
Total Cycle Pressure
Faults
Total Other Faults
Total Fault Hours
Total Low Level Warnings Number of low level warning
Total Cycle Pressure
Warnings
Total Other Warnings
46
The number of lubrication cycles
the unit has started.
Total amount of hours the pump
has been in the ON mode of the
ON/OFF cycle.
Total number of hours that the
unit has been powered on.
The number of times the manual
run button was pressed.
The number of times the remote
manual run button was pressed.
The average amount of time per
lubrication cycle that the pump
has been running (MM:SS).
The average amount of time the
unit has been operating before
the specified feedback for the
sensor input was received (prox-
imity switch counts in divider
valve systems and pressure
switch activation in injector sys-
tems).
The average percentage of time
the unit has been pumping while
it has been powered on.
The highest percentage of time
for one lubrication cycle that the
unit has been pumping while it
has been powered on.
Total number of low level faults.
Total number of faults related to
sensor feedback in an injector or
divider valve system.
Faults other than low level or
sensor feedback.
Number of hours the system has
been powered on in fault mode.
conditions.
Total number of warning condi-
tions related to sensor feedback.
This is only applicable if fault
retries are used.
All other warnings including tem-
perature and motor current.
332305J