Graco G3 Instructions Manual
Stirring paddle replacement kit
Hide thumbs
Also See for G3:
- Instructions manual (88 pages) ,
- Instructions (4 pages) ,
- Instruction manual (77 pages)
Advertisement
Quick Links
Instructions
G3 Stirring Paddle
Replacement Kit
Instructions for replacing stirring paddle. For professional use only.
Part No.: 571044, 571045, 571046, 571047
Important Safety Instructions
Read all warnings and instructions in this
manual and the G3 Pump instruction manual
that was included with your unit. Save these
instructions.
3
Kit Parts
Ref. Description
1
WIPER, stirring
2
BEARING, sleeve
3
O-RING, 258, green
4
PADDLE, stirring
3A0535C
ENG
1
2
4
2 Liter Model shown
Qty
1
1
1
1
Advertisement
Related Manuals for Graco G3
Summary of Contents for Graco G3
- Page 1 Instructions for replacing stirring paddle. For professional use only. Part No.: 571044, 571045, 571046, 571047 Important Safety Instructions Read all warnings and instructions in this manual and the G3 Pump instruction manual that was included with your unit. Save these instructions. 2 Liter Model shown Kit Parts Ref.
-
Page 2: Pressure Relief
Instructions Instructions Pressure Relief Reference numbers used in these instructions corre- spond to parts included in Kit and are provided on page 1. Parts identified with an alpha character are user pro- vided, already installed components or locations neces- SKIN INJECTION HAZARD sary to correctly complete these instructions. -
Page 3: Liter Models
6. For all installations, turn paddle (d) clockwise to loosen and remove it from G3 base (F . 5). 5. Step 5 (a - d) is for G3 Pumps with a follower plate ONLY: a. Verify the following parts were removed with reservoir (F . - Page 4 Instructions 7. Step 7 (a - b) is for G3 Pumps with Low Level Reassembly Paddle ONLY: Always use new parts from kit when available. a. Remove bolt (f) and washers (g) holding low level paddle (e) to stirring paddle (d) and com- 1.
- Page 5 (g) and stirring paddle (4) (F . 11). . 12 4. Install stirring paddle (4) in base of G3. Turn paddle counter-clockwise until it is tighten securely in place (F . 13). (Illustration does NOT show low level paddle.)
- Page 6 F . 15. . 13 5. Step 5 (a - g) is for G3 Pumps with a follower plate ONLY. If your G3 Pump does not include a follower plate, continue Reservoir Installation instructions, page 7.
- Page 7 1/4 turn clockwise till reservoir will not turn any farther. NOTICE Be careful when installing reservoir that o-ring is not pinched. If the o-ring is not correctly installed, grease could leak out of the bottom of the G3 reser- voir. 3A0535C...
- Page 8 All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice. Original instructions. This manual contains English. MM 3A0535...