Exit Menu - Xycom CHIP4e+ User Manual

Exit Menu

Use this menu to exit the setup menus.
PhoenixBIOS Setup–Copyright 1985-95 Phoenix Technologies Ltd.
Main Advanced
Save Changes & Exit
Exit Without Saving Changes
Get Default Values
Load Previous Values
Save Changes
↑↓
F1 Help
←→ Select Menu
ESC Exit
Option
Save Changes & Exit
Exit Without Saving Changes
Get Default Values
Load Previous Values
Save Changes
Security
Select Item -/+
Enter Select
Submenu
Description
Saves the changes you have made during the current session in battery-backed CMOS
RAM, and then exits the setup menus.
After you save your selections, the program displays the following message:
" Values have been saved."
" [Continue]"
When you press continue, the system exits the setup menus.
The next time you boot your computer, the BIOS configures your system according to the
setup selections stored in CMOS. If those values cause the system boot to fail, reboot and
press F2 to enter the BIOS setup menus. Once in the setup menus, you can revert to the
Default Values (as described below) or change the selections that caused the boot to fail.
Exits the setup menus without storing any new selections you may have made. The
previous selections in effect remain in effect.
Loads the default values for all the Setup menus. After you select this option, the program
displays the following message:
" Default values have been loaded."
" [Continue]"
If, during boot up, the BIOS detects a problem with values stored in CMOS, it displays the
following messages:
" System CMOS checksum bad - run SETUP"
" Press <F1> to resume, <F2> to Setup"
This indicates that the CMOS values have been corrupted or modified incorrectly. Press F1
to resume the boot (this causes the system to be configured using the default values) or
F2 to run the BIOS setup menus with the ROM default values already loaded into the
menus. You can make other changes before saving the values to CMOS.
Restores the values you previously saved to CMOS if you change your mind about
changes you have made and have not yet saved .
Saves all the changes you have made during the current session to battery-backed CMOS
RAM, but does not exit the setup menus. You can return to the other menus if you want to
review and change your selections.
Exit
If the item you are
viewing has specific help,
it will be listed here.
Change Values
þ
Item Specific Help
F9 Setup Defaults
F10 Previous Values
43