Boot Sequence Submenu - Xycom CHIP4e+ User Manual

Boot Sequence Submenu

Use this menu toconfigure the boot sequence.
PhoenixBIOS Setup–Copyright 1985-95 Phoenix Technologies Ltd.
Main
Previous Boot:
Boot sequence:
SETUP prompt:
POST Errors:
Floppy check:
Summary screen:
↑↓
F1 Help
Item
←→ Select
ESC Exit
Menu
Option Description
Previous Boot Detects if a boot sequence was not completed properly when enabled. An incomplete boot may be
caused by a power failure, reset during boot up, or invalid CMOS configuration. If the BIOS detects this
condition, it will display the following message: "Previous boot incomplete - default configuration used."
The system is then rebooted using the default configuration. If this option is disabled, the system BIOS
will not detect an incomplete boot. As a result, the system may not boot if the CMOS settings are
wrong.
Boot Sequence Attempts to load the operating system from the disk drives in the sequence selected here.
Setup Prompt Displays the message, "Press <F2> for Setup," during boot up.
POST Errors Halts the system if it encounters a boot error when enabled, and will display "Press <F1> to resume,
<F2> for Setup."
Floppy Check Seeks disk drives on the system during boot up if enabled. Disabling speeds boot time.
Summary Screen Displays system summary screen during boot up when enabled. The default is enabled. This screen is
a standard Phoenix BIOS screen and provides information on the following items:
Processor Type
Coprocessor Type
BIOS Date
System ROM Address
System RAM
Extended RAM
Shadow RAM
Cache RAM
Boot Sequence
[Disabled]
[A: then C:]
[Disabled]
[Enabled]
[Disabled]
[Enabled]
Select -/+
Enter Select
COM Ports
LPT Ports
Display Type
Hard Disk 0
Hard Disk 1
Diskette A
Diskette B
Item Specific Help
If the line item you are
viewing has specific help,
it will be listed here.
Change Values
Submenu
þ
F9 Setup Defaults
F10 Previous Values
37