Advertisement
then
the
battery
continuously
and
replaced.
Back Up Operation
The autonomous duration of battery during
emergency mode is at least the one that is
stated
in
the
characteristics. During emergency mode, a
light source test is also performed.
Resetting Errors
Push the Test button for >10 seconds, to
delete all the indicated LED errors. Then the
device enters regular operation mode.
Test Switch
Pressing the test switch less than 5 seconds
will initiate a light source test (last for 3 secs).
If the test switch is pressed for more than 10
seconds, the device will be reset (delete all
errors).
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personnel
only.
2. The device must be connected to the
m a i n s p o w e r s u p p l y t h r o u g h a f u s e
dependent by the total amount of the line's
power load.
3. The replacement of the battery and the light
source must be done using parts of the same
type, by the manufacturer or by a competent
person.
4. In case of inactive use for a period greater
than 2 months, disconnect the battery by
pulling out the battery's connector.
5. I s not allowed to discard batteries into
t i
common trash bins, they must be
discarded only
points. Do not incinerate.
LEDs
CHARGE
: Battery charging,
LAMP FAULT
: Operation check,
BATT. FAULT
: Autonomy test,
Note
: Blinking,
Page 2 from 6
fault
led
turned
the
battery
must
list
of
the
technical
in battery recycling
Status of LEDs
Description of indication
: battery charged,
: lamp fault,
: battery fault,
: constantly on,
on
Connection to module (After request)
be
This luminaire can be connected to any of the
following modules: Remote module, address
module, wireless module and fault relay
module. If you connect it to a module that
supports inhibit or rest mode, you should
know that these commands can be cancelled
only
during
emergency). For installation refer to step 3 of
the istallation procedure in page 3.
Also refer to the user's manual of each
module for additional information.
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
0: Non maintained (*)
A: Including test device
E: With non-replaceable lamp(s)
F: Automatic test gear complying with IEC
61347-2-7 denoted EL-T
90: 1.5 hour duration
180: 3 hour duration
(*) Non Maintained operation: The luminaire
turns on illumination source, only in case of
power supply failure.
Note!! If a module will be used (except the fault
relay module), then the installer should fill in, on
the specification label, the letters B C.
: disconnected or unfunctional battery
: normal operation
: normal operation
: off
normal
mode
(ie.
X 0
A E F
923221000_09_001
not
in
9 0
Advertisement
