Advertisement
Mounting the lamp in suspended ceiling.
Set up the lamp to the suspended ceiling as it is shown bellow (Required opening 110mm):
Step 1
Bend the springs, to get into the hole of the suspended ceiling, as you can see to the next figure.
Step 2
Push up the luminaire, as shown in figure 2.
Step 3
Continue to push upwards until the lamp locks.
Surface mounting.
Install the luminaire according to the following
Step 1. Follow the step 1 of the installation instructions.
Step 2. Unfasten the retaining screw (Photo 1) and detach the part for suspended ceiling
installation.
Step 3.
Drill 2 holes on the base using a 4mm drill bit in order to permit the retaining screws to pass.
Mark these two drilled points on the required mounting location, drill the holes and install the
supplied plastic plugs.
the light direction as shown on the luminaire's base (Photo 2).
Step 4. Install the decorative rim (package included) as shown on photo 1.
to install the unit to the require location.
Step 5. Follow the steps 2,3 and 4 of the installation instructions.
Retaining fastener
Decorative Rim
Page 4 from 6
Figure 1
Figure 2
Figure 3
If you want to pull off the device, put a flat blade
screwdriver, between the device and the ceiling.
ATTENTION!! When using the corridor lens ensure the correct orientation of
Photo 1
steps:
Drill here
Photo 2
Ø110mm
Next, use the 2 fasteners
Indications
923221000_09_001
Advertisement
