Advertisement
Manufacturer
Model Number
Voltage Range
Nominal Power
Connections
Temperature (tc)
TEST
A-1900
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
0: Non maintained (*)
A: Including test device
*90: 1.5 hour duration
180: 3 hours duration
(*) Non Maintained operation: The luminaire lights its illumination source, only in power
supply's failure.
Maintained operation: The luminaire lights its illumination source, when it is powered by the
The light source contained in this luminaire shall only be replaced by the manufacturer, or his
agent, or a similar qualified person.
NOTE! The light source is non-user replaceable.
Battery replacement
It can be done only by a competent person and after the mains interruption.
1. Detach the front cover by applying pressure using a flat blade screw driver. Next, unfasten the four
retaining screws without removing them and remove the diffusor.
3. Disconnect the connector and remove the old battery.
4. Connect the new battery with the same type (step 2 of the installation instructions) and place it in
the position of the old one.
5. Replace the removed parts and power the device.
Page 5 from 5
LED MODULE CHARACTERISTICS
GR-470
GR-471
Olympia Electronics S.A.
fixed connection between main pcb and led module
55 °C max. across the board
Manual TEST with the A-1900 Test card (not included
and is available only on request). In order to test the
device you must place the card in front of the indications
TEST mark and remove it instantly for TEST.
CAUTION : Do not view directly with bare eyes
GR-472
0205183
5.6-6.6V DC
1W
GR-473
923473001_09_001
Advertisement
