Advertisement
replaced.
Back Up Operation
The autonomous duration of battery during
emergency mode is at least the one that is
stated
in
the
characteristics. During emergency mode, a
light source test is also performed.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personnel
only.
2. The device must be connected to the
m a i n s p o w e r s u p p l y t h r o u g h a f u s e
dependent by the total amount of the line's
power load.
3. The replacement of the battery and the light
source must be done using parts of the same
type, by the manufacturer or by a competent
person.
4. In case of inactive use for a period greater
than 2 months, disconnect the battery by
pulling out the battery's connector.
5 . I
t i
s n o t a l l o w e d t o d i s c a r d
batteries into common trash bins,
they must be discarded only
battery recycling points. Do not
incinerate.
Connection to module (After request)
This luminaire can be connected to any of the
following modules: Remote module, address
module, wireless module and fault relay
module. If you connect it to a module that
LEDs
CHARGE
LAMP FAULT
BATT. FAULT
Note
Page 2 from 6
list
of
the
technical
Status of LEDs
Description of indication
: Battery charging,
: battery charged,
: Operation check,
: lamp fault,
: Autonomy test,
: battery fault,
: Blinking,
: constantly on,
supports inhibit or rest mode, you should
know that these commands can be cancelled
only
during
emergency). For installation refer to step 3 of
the istallation procedure in page 3.
Also refer to the user's manual of each
module for additional information.
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
0: Non maintained (*)
A: Including test device
B: Including remote test mode
C: Including inhibiting mode
F: Automatic test gear complying with IEC
61347-2-7 denoted EL-T
90: 1.5 hour duration
180: 3 hour duration
Maintained operation: The luminaire lights its
illumination source, when it is powered by the
mains power supply or not.
(*) Non Maintained operation: The luminaire
turns on illumination source, only in case of
in
Note!! If a module will be used (except the fault
relay module), then the installer should fill in, on
the specification label, the letters B and C.
: disconnected or unfunctional battery
: normal operation
: normal operation
: off
normal
mode
(ie.
X 0
A F
923293004_09_004
not
in
9 0
Advertisement
