NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
0: Non Maintained (*)
A: Including test device
B: Including remote test mode
C: Including inhibiting mode
F: Automatic test gear complying with IEC 61347-2-7 denoted EL-T
180: 3 hours duration
(*) Non Maintained operation: The luminaire lights its illumination source, only in power supply's
failure.
Maintained operation: The luminaire lights its illumination source, when it is powered by the mains
power supply or not.
The light source contained in this luminaire shall only be replaced by the manufacturer, or
his agent, or a similar qualified person.
NOTE! The light source is non-user replaceable.
Manufacturer
Model Number
Voltage Range
Nominal Power
Connections
Temperature (tc)
INDICATION LED STATUS (with the mains power supply connected)
POWER / CHARGE
Disconnected battery / not charging
Charged battery
Battery under charge
Indicator OFF
Page 3 from 7
LED MODULE CHARACTERISTICS
Cable connection between main pcb and led module
Indicator ON
Indicator Blinking
X 0
A B C F
GRL-29/WP/ADR
Olympia Electronics S.A.
2002163
19-23V
4.9W
60 °C max. across the board
LAMP FAULT / BATT. FAULT
Normal operation mode
Low emergency duration (replace battery)
Lamp fault (Check lamps and replace if needed)
1
8
0
923029012_09_001