Procedures When The System Is Installed In An Enclosure; Removing The Enclosure Rear Panels; Removing The Enclosure Side Panels; Ac Input Conduit Options - Vertiv NetSure 7100 Series Installation Manual

Procedures when the System is Installed in an Enclosure

Removing the Enclosure Rear Panels

Procedure
1. Loosen the fasteners on the rear panel, then remove the panel. Refer to Figure 1.
2. For reassembly, note the location of the large holes in two corners of the panels. Orient the panels as
shown in Figure 1.

Removing the Enclosure Side Panels

Procedure
1. Loosen the fasteners on the side panel including panel frame grounding wire hardware, then remove the
panel. Refer to Figure 1.

AC Input Conduit Options

Two types of conduit plates are available. Select and install the conduit plate appropriate for your application.
Refer to Figure 2.
Figure 1:
Removing System Enclosure Side and Rear Panels
Loosen top screws to
remove side panels.
Removing Side Panels
Vertiv | NetSure 7100 Series -48V DC Power System Installation Manual (IM582127000) | Rev. BB
Removing Rear Panels
17