Maxxus 8.1 Operating Manual And Assembly Manual page 15

STOP Key
Stop/Pause Function:
Press the STOP/RESET key once and the treadmill belt will stop. The cockpit will switch into pause mode for 5
minutes. If the START key is pressed in these five minutes, training will continue from where it stopped. After the five-
minute break, the cockpit will automatically reset, and all values will be set back to Zero.
RESET Function:
If you press the STOP/RESET key for longer than 3 seconds when the device is in pause mode, an acoustic signal
will sound, and all values will be reset.
START Key
Start the Quick Start function or the training program selected.
If using the Pause function, training can be re-started by pressing the START key.
PROGRAM Key (P)
Key for selecting the program.
MODE Key (M)
Key for selecting the training specifications
Heart Rate Measurement
The cockpit of your treadmill is standard equipped with a polar-compatible receiver. A chest belt is available
as an accessory.
Hand Pulse Sensors
Serve for short-term pulse measurement. Please do not touch the hand pulse sensors if you are wearing a chest belt
as this can cause incorrect pulse rate measurements.
Ventilator
Press the Fan Key to turn the ventilator on and off. The incline of the ventilator can be adjusted to suit.
Switching on the Treadmill
Connect the mains plug on the power cable to a grounded, 16 A socket which has an individual fuse and been
installed by a professional electrician.
Now switch on the treadmill with the on / off button (located on the back of the motor housing).
Switching On/Off
Press the On/Off key again to switch off the treadmill. Remove the mains plug from the electrical socket.
CAUTION:
Before you switch off the treadmill, always make sure that the incline level is at zero.
Quick Start
Press the START button.
The treadmill starts automatically after a countdown and the exercise time will start to run.
Use the SPEED keys to adjust the speed, and the INCLINE keys to adjust the incline during your workout.
To have a break or stop the workout, press the STOP button.
Manual Training (P0)
Step 1: Program Selection
After switching on the treadmill, the display will show "P0". If the treadmill is already switched on and the display shows
another program, select the program "P0" by pressing the PROGRAM key.
Step 2: Selecting the Training Target Value
You now have the option of specifying either the training time, the training distance or the calorie consumption as the
target value for your training. The two values that you do not specify are automatically set to zero by the cockpit
Selecting the Training Time:
Press the MODE key once. The display window TIME flashes 30:00 minutes. Specify the desired workout time from
05:00 to 99:00 minutes by pressing the incline or speed control keys.
Cockpit
15