Safety Messages; Warnings - Emerson Rosemount 702DX22 Reference Manual

Reference Manual
00809-0200-4702, Rev CA
Section 8
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 77
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 77
Configuring the transmitter to communicate with the wireless network . . . . . . page 78
Verifying operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 79
AMS Wireless Configurator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 81
8.1

Safety messages

Instructions and procedures in this section may require special precautions to ensure the safety
of the personnel performing the operations. Information that potentially raises safety issues is
indicated by a warning symbol ( ). Please refer to the following safety messages before
performing an operation preceded by this symbol.
8.1.1

Warnings

Failure to follow these installation guidelines could result in death or
serious injury.

Explosions could result in death or serious injury.


Process leaks could result in death or serious injury.


Electrical shock could cause death or serious injury.

Note
The 702 transmitter and all other wireless devices should be installed only after the Gateway has
been installed and is functioning properly.
Wireless devices should be powered up in order of proximity from the Gateway, beginning with
the device closest to the Gateway. This will result in a simpler and faster network installation.
Commissioning: Models 702DX32 and 702DX42
Commissioning: Models
702DX32 and 702DX42
Make sure only qualified personnel perform the installation.
Before connecting a Field Communicator in an explosive atmosphere, make sure the
instruments are installed in accordance with intrinsically safe or non-incendive field
wiring practices.
Verify that the operating atmosphere of the transmitter is consistent with the
appropriate hazardous locations certifications.
Do not remove the switch while in operation.
Install and tighten sensors before applying pressure.
Use extreme caution when making contact with the leads and terminals.
Section 8: Commissioning: Models 702DX32 and 702DX42
February 2013
77