Verifying Operation - Emerson Rosemount 702DX22 Reference Manual

Reference Manual
00809-0200-4702, Rev CA
4.5

Verifying operation

There are four ways to verify operation: using the optional local display (LCD), using the Field
Communicator, using the Smart Wireless Gateway's integrated web interface, or by using AMS
Suite Wireless Configurator. If the 702 transmitter was configured with the Network ID and Join
Key, and sufficient time has passed, the transmitter will be connected to the network.
Troubleshooting
If the device is not joined to the network after power up, verify the correct configuration of the
Network ID and Join Key, and verify that Active Advertising has been enabled on the Gateway.
The Network ID and Join Key in the device must match the Network ID and Join Key of the
Gateway.
Operating the local display
The LCD displays the PV and SV values at the configured update rate, but no faster than once
every 60 seconds.
Diagnostic button display sequence
More detailed diagnostic information can be obtained by removing the display cover of the 702
transmitter, and momentarily depressing the "DIAG" button. The LCD will display the diagnostic
screens as shown in
Press the Diagnostic button to display the TAG, Device ID, Network ID, Network Join Status and
Device Status screens.
Figure 4-2. Diagnostic Screen Sequence
A b c d e
f g h
Network join status
The chevron-shaped status bar at the top of the screen indicates the progress of the network
join process. When the status bar is filled, the device is successfully connected to the wireless
network. This is shown, in
Commissioning: Models 702DX22 and 702DX61
Figure 4-3.
Tag Device ID
i d - 1 2
3 4 5 6 7 8
Figure 4-3 on page
Section 4: Commissioning: Models 702DX22 and 702DX61
Network Join
Network ID Status
n e t w k n e t w k
13 0 5
I D O K
32.
February 2013
Device Status
S u p l y
7. 2 1
v o l t s
®
31