Disk Drive Status Indicators - Avaya Sun Fire V880 Installation & Maintenance

Troubleshooting

Disk drive status indicators

The disk fault LED on the system status and control panel indicates the general status of the
disk subsystem. The disk fault LED lights when a fault is detected in the disk subsystem. LEDs
inside the system indicate the fault status of individual disk drives.
There are three LEDs (Activity, Fault, OK-to-remove) for each disk drive. The disk drive LEDs
are located on the front of the disk cage, as shown below.
The disk drive LEDs are defined as follows:
Name
Activity
Fault
OK-to-remove
182
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting
Icon
Blinks slowly while the disk drive is being tested,
configured, or unconfigured during a hot-plug operation.
Blinks rapidly as the disk drive spins up or spins down.
Stays lit when the disk drive is at speed and operating
normally but experiencing no read or write activity. Blinks
rapidly and irregularly in response to disk read or write
activity.
Lights when the disk drive encounters a fault.
Lights when it is safe to remove the disk drive during a
hot-plug operation.
Blinks (under software control) to direct attention to a
disk drive.
LED function
May 2006